ENGINE AR-COMPLETE 2142945 - Caterpillar

Illustration 13 g03341727
Assemble two tube assemblies (52) using union (53) and o-ring seals (54) .
Assemble tube assemblies (52), (55), (56) to the back of the bulldozer blade by using six blocks (57) and six bolts (58) .
Illustration 14 g03341728
Assemble hose assemblies (59), and (60) to the tilt cylinders by using two o-ring seals (61), four half flanges (62), eight bolts (63), and eight hard washers (64) .
Assemble the other end of the hose assemblies to the tube assemblies that were installed to the back of the blade in step 19. Use two o-ring seals (54) .
Assemble the hose clip near the midpoint of the hoses by using clip (65) and (66), grommet (67), two bolts (68), four washers (69), and two nuts (70) .
Repeat step 20 through 22 for the right tilt cylinder.
Illustration 15 g03342595
Assemble guard (71) to the tilt cylinder by using two bolts (72), four hard washers (74), and two locknuts (73) .
Assemble the head end hose to guard (71) by using clips (75) and (76), grommet (77), bolt (63), nut (70), and washer (69) .
Repeat steps 24 and 25 for the right tilt cylinder. Assemble guard (78) on the right-hand cylinder.
Illustration 16 g03342594
Assemble the 90° end of the two hose assemblies (79) to the front of the tractor by using existing hardware. Use two new o-ring seals (61) .
Secure the two hoses to the front of the tractor by using clips (75) and (76), grommet (77), washers (69), and bolts (58) .
Illustration 17 g03342593
Assemble the other end of two hose assemblies (79) to the tube assemblies that were assembled to the back of the blade in step 19. Use two o-ring seals (61), four half flanges (62) eight hard washers (64), and eight bolts (63) in order to connect the hose assemblies to the tube assemblies.Note: The upper hose assembly should be assembled to the tube assembly on the left. The lower hose assembly should be assembled to the tube assembly on the right.
Assemble the hose clip by using clip (65) and (66), grommet (67), two bolts (68), two nuts (70), and four washers (69) .
Illustration 18 g03342588
Assemble guard assembly (80) and guard (81) onto the back of the blade by using six bolts (82), and six hard washers (83) .