GAUGE-OIL LEVEL (DIPSTICK) 2G8898 - Caterpillar

Using a standard web browser, navigate to the PL1000E Communication ECM Home Page by entering either the Internet Protocol (IP) address or Host Name. The PL1000E Communication ECM Home Page will be displayed.Note: See this System Operation Troubleshooting Testing and Adjusting, RENR8091, "PL1000E Communication ECM" for information about the configuration of the ECM and the PC for either direct cross over connection or network connection.Available embedded web pages can be accessed with the left navigation menu shown in Illustration 1. The following sections explain each available web page and the contents of the web pages.
Illustration 1 g01720178
Events / Diagnostics
The following web pages display active events and diagnostic information. The active events and diagnostic information are from ECMs that are currently sending data to CDL or to the J1939 data link.Note: A translation line to a web object must exist in the PCL file for the event and the diagnostic information to be displayed on this page. This translation line must include the desired active events and / or the active diagnostics parameters.
Illustration 2 g01717075
DiagnosticsEvents
Illustration 3 g01717145
Configuration
The Configuration pages are an alternate means of setting the ECM Configuration Parameters that are available in the service tool.Clicking on the small symbol to the left of "Configuration" (refer to the navigation menu shown in Illustration 4) will cause additional page links to be displayed under "Configuration". These additional page links are as follows:
Cat Data Link
Internet Protocol
Modbus
Password
Reset
Illustration 4 g01720181
Internet Protocol Configuration
Refer to Illustration 5 for an example of an IP Configuration screen that shows parameters that may be customized for the application. The illustration will also display the status of those parameters that may need to be monitored for use in verification or troubleshooting.
Illustration 5 g01720734
MAC Address – Assigned at manufacture time, this value is read only and will be required by a network administrator to properly set up the ECM on the network.Host Name – If Dynamic Host Configuration Protocol (DHCP) is enabled, the host name must be programmed with a descriptive name of the PL1000E device or its function in the system. Consult the network administrator to determine the appropriate Host Name for the device.IP Address – This field is only applicable if DHCP is not enabled. If DHCP is disabled, then a static IP address must be defined here. This is also used when connecting a PC directly to the ECM using a cross-over cable. See this System Operation Troubleshooting Testing and Adjusting, RENR8091-01, "Explorer Gateway Service Manual" for details on connecting to this device directly using a cross-over cable.SubNet Mask – If connecting to a network, contact the network administrator for the appropriate configuration of the SubNet Mask. If DHCP is not enabled, this will be required for static IP addressing.Default Gateway IP Address – If connecting to a network, contact the network administrator for the appropriate configuration of the Default Gateway IP Address. If DHCP is not enabled, this will be required for static IP addressing.DHCP – Dynamic Host Configuration Protocol is a process by which a device on a network may