HARNESS ASSEMBLY 1182943 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the proper procedure.
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release" for the proper procedure.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from machine articulation or movement.Machine frames can move and a person can be crushed.Connect the steering frame lock link between the front and rear frames before working on machine. Secure clevis pin with locking pin.Before operating the machine, fasten the steering frame lock link into the stored position and secure the clevis pin with locking pin.Failure to lock into the stored position before operating can result in loss of steering.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hose assemblies for installation purposes. Plug all hose assemblies in order to prevent fluid loss and contamination of the hydraulic system.
Illustration 1 g01004931
Disconnect hose assemblies (2) from metering pump (1) .
Illustration 2 g01004932
Remove floormat (3) .
Illustration 3 g01004933
Remove bolts (4) .
Lower the metering pump.
Illustration 4 g01004934
Remove bolts (5) and plate (6) from the metering pump.
Remove the metering pump from the machine.
Illustration 5 g01004935
Remove fittings (7) .