HARNESS ASSEMBLY-STEERING COLUMN 2833367 - Caterpillar

Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01333881
Typical example
If necessary, follow Steps 1.a through 1.e in order to assemble the engine oil cooler.
Ensure that cooler matrix (6) is clean and free from damage. Ensure that cover (7) is clean and free from damage.
Position new O-ring seals (12) and (13) onto cover (7) .
Install cooler matrix (6) to cover (7) .
Install nuts (8). Tighten the nuts to a torque of 18 N m (13 lb ft).
Install joint (9) and plate (10) .
Clean the mating surface of the cylinder block.
Install new O-ring seals (4) to the recesses in the cylinder block.
Install two bolts (11) to the upper corners of the assembly of engine oil cooler (3). Install a new joint (5) to the assembly of engine oil cooler (3) .
Install the assembly of engine oil cooler (3) to the cylinder block. Install the remaining bolts (11) .Note: Ensure that any brackets that are secured by the bolts are installed in the correct location.
Tighten bolts (11) evenly to a torque of 18 N m (13 lb ft).
Illustration 2 g01361343
Typical example
Install dipstick tube (1) .
For turbocharged engines, install crankcase breather (2). Refer to Disassembly and Assembly, "Crankcase Breather - Remove and Install".
Fill the cooling system to the correct level. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct procedure.
Fill the engine oil pan to the correct level. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change" for the correct procedure.End By: Install the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Install".