Lafayette 3616 Engine VRQ4700 - Caterpillar

Table 1
Troubleshooting Test Steps Values Results
1. Programming a Flash File
A. Establish communication between the Cat® Electronic Technician (CatET) Service Tool and the Machine ECM.
B. Select "WinFlash" from the "Utilities" menu on Cat ET.
If "WinFlash" will not communicate with the ECM, refer to Troubleshooting, UENR0515, "Electronic Service Tool Does Not Communicate".
C. Program the flash file into the ECM.
D. Select the Machine ECM under the "Detected ECM modules".
E. Press the "Browse" button to select the name of the flash file that will be programmed into the ECM.
F. When the correct flash file is selected, press the "Open" button.
G. Verify that the "File Values" match the application. If the "File Values" do not match the application, obtain the correct flash file.
H. When the correct flash file is selected, press the "Begin Flash" button.
I. CatET will indicate when flash programming has been successfully completed.
J. Start the machine and check for proper operation. Repair any active diagnostic or event codes.
Programmed successfully. Result: The flash programming was successful.
Return the unit to service.
Result: The flash programming was not successful.
Repair any active diagnostic or event codes. Proceed to Test Step 2.
2. "WinFlash" Error Messages
A. If you receive any error messages during flash programming, click the "Cancel" button to stop the process. Access the information about the "ECM Summary" under the "Information" menu. Make sure that you are flashing the correct file for your machine.
B. Record all error messages. The recorded error messages will be necessary if further assistance is needed.
Error messages. Result: There are no error messages.
Return the unit to service.