MOTOR AS-WINDOW WIPER 1310399 - Caterpillar

Troubleshooting the Marine Monitoring System II requires additional information from the machine's Service Manual. The additional manuals that may be required are the System Schematic, and the Parts Manual for the machine that is being serviced.When the troubleshooting procedure instructs you to "REPAIR THE WIRING", use the Electrical System Schematic for the machine that is being serviced to trace the circuit. Perform continuity checks at the harness connectors in order to locate harness failures. At the connectors of the components, always check the ground circuit. Less than five ohms of resistance is required between the ground contacts of the connector and the frame ground. Excessive ground resistance that is greater than five ohms can cause incorrect diagnosing of problems.During troubleshooting, inspect all connections before any component is replaced. If these connections are not clean and tight, permanent electrical problems or intermittent electrical problems can result. Check that the wires are pushed into the connectors completely. Make sure that the connections are tight before other tests are made.Failure of an electrical component can cause the failure of other components. Also, failure of an electrical component can be caused by the failure of other components. Always attempt to correct the cause of an electrical system failure before you replace a component.