0951571 SEAL-O-RING Caterpillar parts
303.5C, 303.5D, 303.5E, 303C CR, 304C CR, 304D CR, 304E, 305.5D, 305.5E, 305C CR, 305D CR, 305E, 307, 307B, 311B, 312B, 315B, 318B, 320B, 320B FM LL, 320N, 322 FM L, 322B, 322B L, 322B LN, 325, 325 LN...
Rating:
Alternative (cross code) number:
CA0951571
095-1571
0951571
CA0951571
095-1571
0951571
Weight: 16 pounds 7 kg.
Information:
CROSS SECTION DIAMETER
1.9
mm
ID
2.8
mm
MATERIAL
Nitrile (NBR) Rubber 90 Duro
OD
0
mm
EXCAVATOR, WHEELED EXCAVATOR,
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
$4.39
06 Oct 2018
CATERPILLAR AFTERMARKET: CATERPILLAR AFT
CATERPILLAR SEAL O RING 0951571 NEW
$4.07
11 Jun 2022
0.1102[0.05] Pounds
US: TakePart
CTP Caterpillar Nbr (90) O-Ring (0951571) Aftermarket
CTP
CTP
Number on catalog scheme:
11
For full view, you need register
Compatible equipment models: 0951571:
Information:
Introduction
Troubleshooting can be difficult. The following pages contain a list of possible problems. In order to make a repair to a problem, refer to the cause and the correction of the problem.The list on the following pages will provide the following information:
Known problems
Probable causes of known problems
Repairs in order to correct known problemsNormally, additional repair work is needed beyond the recommendation in the list.Remember that a problem is not normally caused by only one part. The problem's cause can be related to problems with other parts. This list does not include all possible problems and corrections. The service technician must find the problem and the problem's source. After the problem's source is determined, the service technician can make the necessary repairs.Troubleshooting Problem List
The Shutoff Solenoid Fails To Stop The Engine.
The Contactor Switch For Water Temperature Does Not Activate The Shutoff Solenoid.
The Contactor Switch For Water Temperature Activates At Wrong Temperature.
The Contactor Switch For The Oil Pressure Does Not Activate The Shutoff Solenoid.
The Electrical Gauges Give Wrong Readings.
There Is No Output From The Governor.
The Engine Has Slow Response To A Change In Speed Setting Or Load.
The Engine Speed Does Not Have Stability.
The Engine Will Not Drive A Full Load.
The Clutch Will Not Engage Or The Lever Moves To The Released Position.
The Clutch Shaft Has Too Much End Play.
The Clutch Bearing Has Short Life. Troubleshooting Problems
Problem 1
The Shutoff Solenoid Fails To Stop The Engine.Probable Cause
There Is A Poor Connection. Check connections and wiring.
The Adjustment For The Plunger Shaft Is Incorrect. Make adjustments to the plunger shaft.
The Plunger Is Incorrect In The Shutoff Solenoid. Install the correct plunger shaft.
There Is Not Enough Plunger Travel. Make an adjustment to the plunger shaft. Replace the solenoid if it is necessary.Problem 2
The Contactor Switch For Water Temperature Does Not Activate The Shutoff Solenoid.Probable Cause
There Is Low Water Level In The Cooling System. Fill the cooling system.
There Is A Poor Connection. Check connections and wiring.
The Water Temperature Contactor Switch Has Failed. Check the water temperature contactor switch.
The Setting Of Switch Is Incorrect. Make a test of temperature setting. Install a new contactor switch with the correct setting if it is necessary. See Specifications.
There Is A Failure Of The Shutoff Solenoid. Check the shutoff solenoid.Problem 3
The Contactor Switch For Oil Pressure Does Not Activate The Shutoff Solenoid.Probable Cause
There Is A Poor Connection. Check the connections and wiring.
The Setting Of The Switch Is Incorrect. Make a test of the temperature setting. Install a new contactor switch with the correct setting if it is necessary. See Specifications.Problem 4
The Electrical Gauge Gives The Wrong Reading.Probable Cause
There Is A Poor Connection. Check the connections and wiring.
The Sending Unit Has Failed. Check the sending unit. Install a new sending unit if it is necessary.
The Resistor In A 32 Volt System Has Failed. Install a new resistor.
The Sending Unit Is Incorrect. Install the correct sending unit.
The Gauge Is Incorrect. Install the correct gauge.Problem 5
There Is No Output From The Governor.Probable Cause
The Engine Cranking Speed Is Too Slow. Make reference to Troubleshooting in
Troubleshooting can be difficult. The following pages contain a list of possible problems. In order to make a repair to a problem, refer to the cause and the correction of the problem.The list on the following pages will provide the following information:
Known problems
Probable causes of known problems
Repairs in order to correct known problemsNormally, additional repair work is needed beyond the recommendation in the list.Remember that a problem is not normally caused by only one part. The problem's cause can be related to problems with other parts. This list does not include all possible problems and corrections. The service technician must find the problem and the problem's source. After the problem's source is determined, the service technician can make the necessary repairs.Troubleshooting Problem List
The Shutoff Solenoid Fails To Stop The Engine.
The Contactor Switch For Water Temperature Does Not Activate The Shutoff Solenoid.
The Contactor Switch For Water Temperature Activates At Wrong Temperature.
The Contactor Switch For The Oil Pressure Does Not Activate The Shutoff Solenoid.
The Electrical Gauges Give Wrong Readings.
There Is No Output From The Governor.
The Engine Has Slow Response To A Change In Speed Setting Or Load.
The Engine Speed Does Not Have Stability.
The Engine Will Not Drive A Full Load.
The Clutch Will Not Engage Or The Lever Moves To The Released Position.
The Clutch Shaft Has Too Much End Play.
The Clutch Bearing Has Short Life. Troubleshooting Problems
Problem 1
The Shutoff Solenoid Fails To Stop The Engine.Probable Cause
There Is A Poor Connection. Check connections and wiring.
The Adjustment For The Plunger Shaft Is Incorrect. Make adjustments to the plunger shaft.
The Plunger Is Incorrect In The Shutoff Solenoid. Install the correct plunger shaft.
There Is Not Enough Plunger Travel. Make an adjustment to the plunger shaft. Replace the solenoid if it is necessary.Problem 2
The Contactor Switch For Water Temperature Does Not Activate The Shutoff Solenoid.Probable Cause
There Is Low Water Level In The Cooling System. Fill the cooling system.
There Is A Poor Connection. Check connections and wiring.
The Water Temperature Contactor Switch Has Failed. Check the water temperature contactor switch.
The Setting Of Switch Is Incorrect. Make a test of temperature setting. Install a new contactor switch with the correct setting if it is necessary. See Specifications.
There Is A Failure Of The Shutoff Solenoid. Check the shutoff solenoid.Problem 3
The Contactor Switch For Oil Pressure Does Not Activate The Shutoff Solenoid.Probable Cause
There Is A Poor Connection. Check the connections and wiring.
The Setting Of The Switch Is Incorrect. Make a test of the temperature setting. Install a new contactor switch with the correct setting if it is necessary. See Specifications.Problem 4
The Electrical Gauge Gives The Wrong Reading.Probable Cause
There Is A Poor Connection. Check the connections and wiring.
The Sending Unit Has Failed. Check the sending unit. Install a new sending unit if it is necessary.
The Resistor In A 32 Volt System Has Failed. Install a new resistor.
The Sending Unit Is Incorrect. Install the correct sending unit.
The Gauge Is Incorrect. Install the correct gauge.Problem 5
There Is No Output From The Governor.Probable Cause
The Engine Cranking Speed Is Too Slow. Make reference to Troubleshooting in
Cat SIS web machinery list:
Parts seal Caterpillar catalog:
328D LCR, 330C L, 330D, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 L, 345C MH, 345D L, 349D L, 349E, 349E ...
330C, 330D L, 330D MH, 345B II, 345B II MH, 345B L, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L
330C, 330D L, 330D MH, 345B II, 345B II MH, 345C, 345C L, 345C MH, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L HVG, 349E L VG, 349F L, 374D L, 374F L
345B II, 345C, 345C L, 365B, 365B II, 365C, 365C L, 365C L MH, 374D L, 374F L
328D LCR, 345B II, 345B L, 345C, 345C L, 345D L, 349E L, 349E L VG, 349F L, 350, 365B, 365B II, 365B L, E650
345B II, 345B L, 350, 365B, 365B II, 365B L
330, 330 FM L, 330 L, 330B, 330B L, E120B, W330B
330B, 330B L, 345B, 345B L, W330B
345B II, 345C, E120, E140, E180, E240, E240C, E300, E300B, E450, EL240B
325B L
325B
311C, 313D2 LGP, 315C, 315D L, 316E L, 318B, 318C, 318D L, 318D2 L, 318E L, 319D, 319D L, 319D LN, 320 L, 320B, 320B L, 320C, 320C L, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2,...
1991904
SEAL-O-RING
305, 307C, 308C, 312B, 318B, 318C, 321B, 325B, 330B, 375
305, 307C, 308C, 312B, 318B, 318C, 321B, 325B, 330B, 375
318B, 318C, 319D L, 319D LN, 320B, 320B FM LL, 320C, 320C FM, 320D, 320E, 320E RR, 322, 322B, 322C, 324D, 324D L, 324E, 324E L, 324E LN, 325B, 325C, 325C L, 326D L, 328D LCR, 330C L, 345B II, 345C, 37...
303.5C, 303.5D, 303.5E, 303C CR, 304.5, 304D CR, 304E, 305.5, 306, 308E, 308E CR, 308E SR, 308E2 CR, 318B, 318C, 319D L, 319D LN, 320B, 320B FM LL, 320C, 320C FM, 320D, 320E, 320E RR, 322, 322B, 322C,...
318B, 318C, 319D L, 319D LN, 320D, 320D FM, 320D L, 323D L, 323D LN, 323D SA, 324D, 324D L, 325D, 325D L, 328D LCR, 329D, 329D L, 345B II, 345C
318B, 318C, 319D L, 319D LN, 320D, 320D FM, 320D L, 323D L, 323D LN, 323D SA, 324D, 324D L, 325D, 325D L, 328D LCR, 329D, 329D L, 345B II, 345C
4I4287
SEAL
307, 307B, 311, 311B, 312, 312B, 315, 318B, 320 L, 320B, 320N, 322 FM L, 322B L, 325, 325B, 330, 330 FM L, 330 L, 345B II, 345B L
307, 307B, 311, 311B, 312, 312B, 315, 318B, 320 L, 320B, 320N, 322 FM L, 322B L, 325, 325B, 330, 330 FM L, 330 L, 345B II, 345B L
4I4353
SEAL
307, 307B, 311, 311B, 312B, 315, 318B, 320 L, 320B, 320N, 322 FM L, 322B L, 325, 325B, 330, 330 FM L, 330 L, 345B II, 345B L, 375
307, 307B, 311, 311B, 312B, 315, 318B, 320 L, 320B, 320N, 322 FM L, 322B L, 325, 325B, 330, 330 FM L, 330 L, 345B II, 345B L, 375
311B, 318B, 320B FM LL, 320N, 322B, 325 L, 325B
307B, 307C, 307D, 308C, 308D, 311B, 311C, 311D LRR, 312C, 312C L, 312D, 312D L, 312D2, 314C, 314D LCR, 315C, 315D L, 318B, 318C, 319C, 319D, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320...
307C, 307D, 311B, 311C, 312C L, 315, 315C, 318B, 318C, 320C, 320C L, 320D, 320D L, 320D LRR, 320D RR, 322, 322B L, 322B LN, 322C, 323D L, 324D, 324D L, 325B L, 325C, 325D, 325D L, 329D, 329D L, 330, 3...
1772645
SEAL-O-RING
315B, 315C, 318B
315B, 315C, 318B