SEAT BELT GP 1229625 - Caterpillar

Remove Fuel Injection Pump Housing & Governor
Start By:a. remove fuel injection linesb. remove governor & fuel pump drive FLUID SPILLAGE CONTAINMENT Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to "TOOLS AND SHOP PRODUCT GUIDE, NENG2500", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose fluids according to local regulations and mandates. 1. Disconnect two fuel lines (1) to the fuel transfer pump. Cap or plug immediately 2. Remove two bolts, washers and spacers (2). 3. Remove two bolts, washers and spacers (3). 4. Remove three bolts and washers (4).5. Remove bracket (5). 6. Remove two bolts and washers (6).7. Remove bracket (7). 8. Disconnect two hoses (8). Cap and plug all openings immediately. 9. Attach a lifting sling and a suitable lifting device to fuel injection pump housing & governor (9) as shown.10. Move fuel injection pump housing & governor (9) back towards the rear of the engine until clear of the governor and fuel pump drive housing.11. Remove fuel injection pump housing & governor (9). The weight of the fuel injection pump housing & governor is 56 kg (125 lb).12. Remove the two O-ring seals on the bottom of the fuel injection pump housing & governor.13. Remove the O-ring seal on the front of the fuel injection pump housing & governor.Install Fuel Injection Pump Housing & Governor
Inspect all O-ring seals prior to installation for wear or damage. If necessary, replace with new O-ring seals.
Make sure there is no paint, dirt or other foreign material on the machined surfaces of the engine or fuel injection pump housing. Be careful not to damage the O-ring seals for the oil inlet and oil outlet as the pump is put into position on the engine.
1. Install the O-ring seal located on the front of the fuel injection pump housing and governor.2. Install the two O-ring seals located on the bottom of the fuel injection pump housing and governor.3. Put a light layer of 5P-0960 Multi-Purpose Grease on the O-ring seal located at the front of the fuel injection pump housing and governor and on the two O-ring seals found on the bottom of the fuel injection pump housing and governor (oil inlet and oil outlet).4. Attach a lifting sling and a suitable lifting device to fuel injection pump housing and governor (9) as shown.5. Put fuel injection pump housing and governor (9) in position on the cylinder block. 6. Connect two hoses (8) to the fuel injection pump housing. 7. Put bracket (7) in position and install two bolts and washers (6). 8. Put bracket (5) in position and install three bolts and washers (4). 9. Install two bolts, washers and spacers (3). 10. Install two bolts, washers and spacers (2). 11. Connect two fuel lines (1) to the fuel transfer