SEAT GP-SUSPENSION 1755124 - Caterpillar

The hydraulic tank is located on the right rear side of the machine. 1. Maintain the oil level to the FULL mark in the sight gauge. 2. Remove the oil fill cap and add oil, if necessary, through the fill tube.3. Clean and install the fill cap.Radiator
Check Coolant Level
At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
1. The radiator cap is located in the top hood of the machine at the left front. 2. Remove the radiator cap slowly to relieve pressure.3. Maintain the coolant level to within 13 mm (.50 in) of the bottom of the fill pipe. If it is necessary to add coolant daily, check for leaks.4. Inspect the cap and cap seal for damage, deposits, or foreign material. Clean the cap with a clean cloth or replace the cap if it is damaged.5. Install the cap.6. Inspect the radiator core for debris and clean if necessary.Compressed air is preferred, but high pressure water or steam can be used to remove dust, leaves, and general debris from a radiator. Clean as required by condition of radiator.Fuel Tank
Drain Water and Sediment
Drain valve is located at the rear of the machine under the fuel tank. 1. Open the drain valve and allow the water and sediment to drain into a suitable container.2. Close the drain valve.Brakes, Indicators, and Gauges
Test for Proper Function
Check operation of the CMS, by observing the self-test each time the engine is started.The CMS control performs an automatic self-test at start-up each time the key start switch is turned to the ON position. During this six second test, observe the following:* The action light does not flash but remains continuously on.* The action alarm beeps once.* All LED alert indicators flash.* All bar graphs (gauge displays) move from zero to maximum and return to zero.* The 4 digit tachometer readout displays: Machine code "22" for two seconds, then software version, like "06.0", for two seconds, then & "8.8.8.8" for the last two seconds.* "Serv Code" indicator is on for two seconds, then off for two seconds, then back on for the last two seconds.* RPM indicator is off for four seconds, then on for two seconds.If the above tests complete as indicated, turn the key start switch to start the engine.If the above tests are not completed as indicated, the CMS control does not go into the operating mode as if ready to crank the engine. Have the electrical system checked and all necessary repairs made before starting the engine.Turn all machine lights on. Check for proper operation.Sound the forward horn.Move the machine forward and test the service brakes. If service brakes do not function properly see the topic Brakes under Every