SWITCH AS 5C6108 - Caterpillar

- 24 DCV
1 - 32 DCV     0    
P08     Upper Display Enable/Disable     Informs the GSC to enable or disable the showing of AC values on the upper display.     0 - upper display enabled
1 - upper display disabled     0    
P08 (2)     Engine Type     Informs the GSC of the type of engine that is in the genset. The engine is either a diesel or a gas engine.     0 - diesel engine
1 - gas engine     0    
P09     Number Of Ring Gear Teeth     Number of teeth on the ring gear engine. Used by the GSC to determine engine speed.     95 to 350 teeth in increments of 1     136    
P10     Engine Overspeed     Engine speed used by the GSC to declare that an engine overspeed fault exists. The engine overspeed setpoint (for all 60 Hz applications) is 1.18 times the rated speed.     500 to 4330 rpm in increments of 10     2120 rpm    
P11     Crank Terminate Speed     Engine speed used by the GSC to disengage the starting motor during engine cranking.     100 to 1000 rpm in increments of 10     400 rpm    
P12     Oil Step Speed     Engine speed used by the GSC for distinguishing between rated speed and idle speed when a low oil pressure fault exists.     400 to 1800 rpm in increments of 10     1350 rpm    
P13 (3)     Low Oil Pressure Shutdown At Rated Speed     Oil pressure used by the GSC to declare that a low oil pressure shutdown fault exists with engine at rated speed (the engine must have exceeded the oil step speed for at least nine seconds).    
34 to 420 kPa (5 to 61 psi) in increments of one.    
205 kPa (30 psi)    
P14 (3)     Low Oil Pressure Shutdown At Idle Speed     Oil pressure used by the GSC to declare that a low oil pressure shutdown fault exist with the engine at idle speed (the engine must have been running for at least nine seconds and the engine speed must be less than oil step speed).    
20 to 336 kPa (3 to 49 psi) in increments of 1    
70 kPa (10 psi)    
P15 (4)     High Water Temperature Shutdown     Coolant temperature used by the GSC to declare a high coolant temperature shutdown fault exists (after a 10 second delay).    
94 to 123°C (201 to 253° F) in increments of 1    
107°C (225°F)    
P16     Low Water Temperature Alarm     Coolant temperature used by the GSC to declare that a low temperature alarm fault exists (after a 2 second delay). (Determined by application or customer.)    
0 to 36°C (32 to 97°F) in increments of 1    
21°C (70°F)    
P17     Total Cycle Crank Time     Cycle crank time used by the GSC to declare that an overcrank fault exists. ( Determined by application or customer.)