TANK AS-WINDOW WASHER 1313714 - Caterpillar

Illustration 1 g02403259
Illustration 2 g02403260
Attach Tooling (G) to the undercarriage frame and attach suitable chains to Tooling (G). Use Tooling (G) and the suitable chains to position the undercarriage frame to the upper structure.
Install Tooling (H) into the upper structure.
Apply Tooling (J) to the top of swing bearing (17).
Illustration 3 g02403261
Illustration 4 g01204405
Use Tooling (E) and Tooling (A) to lower the upper structure. Apply Tooling (K) to the threads of bolts (16). Use Tooling (F) to install bolts (16). Tighten bolts (16) to a torque of 250 25 N m (185 18 lb ft).
Turn bolts (16) to an additional angle of 70 5 degrees. Refer to Service Magazine, M0083843 , "An Improved Bolt Tightening Procedure for the Critical Joints Is Now Used on All Excavators", for detailed information.
Remove Tooling (D) and Tooling (E) from the counterweight.
Illustration 5 g01200687
Attach a suitable lifting device to Tooling (D) and remove Tooling (D) from Tooling (E). The weight of Tooling (D) is approximately 249 kg (550 lb).
Illustration 6 g02403258
Apply Tooling (L) to the threads of bolts (8). Install boot (15), retainer (7), bolts (8), and clamp (14). Tighten bolts (8) to a torque of 37 4 N m (27 3 lb ft). Tighten clamp (14) to a torque of 5 N m (44 lb in).
Install support (12) and bolts (13).
Install tube assembly (10).
Connect hose assemblies (11) and fitting assembly (6) to swivel (9).
Return the brake and the brake valve to the original condition. Refer to Operation and Maintenance Manual, "Towing The Machine".
Illustration 7 g02403257
Apply Tooling (M) to the threads of bolts (4). Use two people to install cover assembly (5). The weight of cover assembly (5) is approximately 25 kg (55 lb). Install cover assembly (5) and bolts (4).
Illustration 8 g02403256
Attach a suitable lifting device to Tooling (C). Remove retainer (2) and pin assembly (3). Remove Tooling (C). The weight of Tooling (C) is approximately 408 kg (900 lb).
Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change" for the correct filling procedure.
Install the right side boom cylinder.
Illustration 9 g01204400
Raise the boom and remove Tooling (A) and (B) from stick (1).End By:
Install the bucket.