TERMINAL-RECEPTACLE 1135184 - Caterpillar

Table 1
Required Tools    
Part Number    Description    Qty    
8T-0856     Pressure Gauge (6000 kPa (870 psi))     1    
Place the machine on level ground.
Stop the engine.
Release the pressure in the hydraulic system. Refer to Testing and Adjusting, "Hydraulic System Pressure - Release".
Illustration 1 g00816979
Pilot oil manifold compartment (28) Locknut (29) Adjustment screw (30) Pressure tap (31) Pilot filter
Connect a 6000 kPa (870 psi) pressure gauge to pressure tap (30) .
Start the engine.
Place the machine controls at the following settings: engine speed dial "10" and AEC switch OFF. Refer to Testing and Adjusting, "Engine Performance - Test (Engine Speed)" for engine rpm settings.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Check the pilot relief valve setting at pressure tap (30) .
The pilot relief valve setting should be 4100 200 kPa (595 30 psi). If the pilot relief valve setting is not within the specification, adjust the pilot relief valve.
In order to adjust the pilot relief valve, loosen locknut (28) .
Turn adjustment screw (29) until the pressure gauge reading at pressure tap (30) is 4100 200 kPa (595 30 psi).Note: Turn adjustment screw (29) clockwise in order to increase the pressure. Turn adjustment screw (29) counterclockwise in order to decrease the pressure.Note: Always make final pressure adjustments on pressure rise.
Tighten locknut (28) to a torque of 49 4.9 N m (36 4 lb ft).Note: Normal operation of the engine and pumps are necessary for the pressure adjustment. If the results of the pressure adjustments are not correct, then the engine and the pump characteristic curve needs to be checked.