VALVE GP-SELECTOR 1659470 - Caterpillar

Illustration 1 g01338732
Connections of the transmission oil temperature sensor
This diagnostic code is associated with the transmission oil temperature sensor. The FMI 3 means that the ECM has determined that the voltage of the circuit for the sensor is above normal.The possible causes of this diagnostic code are listed below:
The transmission oil temperature is too high.
The signal circuit for the sensor is open.
The signal circuit for the sensor is shorted to a higher voltage.
The sensor has failed.
The power circuit or the ground circuit has failed.
The ECM has failed. This is unlikely.Note: Do not connect the sensor to +battery voltage.The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of SPN 177 FMI 3 is active before performing this procedure.Note: Use a digital multimeter for the measurements in this procedure.System Response:A warning of a level 1 is generated. Use the default value.Test Step 1. CHECK FOR POWER AT THE SENSOR.
Do not disconnect the harness connector from the sensor.
Turn the key start switch and the disconnect switch to the ON position.
At the back of the harness connector for the sensor, insert a multimeter probe along the voltage supply wire (contact 1).
Measure the voltage from contact 1 to frame ground. Expected Result:The voltage is 5 DCV.Results:
OK - The voltage is 5 DCV. Proceed to Test Step 2.
NOT OK - The voltage is not 5 DCV. The + battery circuit in the machine harness has failed.Repair: Replace the machine harness or repair the machine harness.STOPTest Step 2. CHECK FOR PROPER GROUND AT THE SENSOR.
The machine harness remains connected to the sensor.
Turn the key start switch and the disconnect switch to the OFF position.
Remove the multimeter probe from the voltage supply wire (contact 1).
At the back of the harness connector for the sensor, insert a multimeter probe along the ground wire (contact 2).
Measure the resistance from contact 2 to frame ground. Expected Result:The resistance is less than 5 ohms.Results:
OK - The resistance is less than 5 ohms. The ground circuit is correct. Proceed to Test Step 3.
NOT OK - The resistance is greater than 5 ohms. The ground circuit in the machine harness has failed.Repair: Replace the machine harness or repair the machine harness.STOPTest Step 3. CHECK THE WIRING HARNESS OF THE SENSOR FOR AN OPEN CIRCUIT.
The key start switch and the disconnect switch remain in the OFF position.
Disconnect the machine harness from the sensor.
At the harness connector for the sensor, connect a jumper wire between contact 1 and contact 2.
Disconnect the machine harness connector(s) from the ECM.
At the harness connector for the ECM, measure the resistance between contact J1-12 and contact J1-62. Expected Result:The resistance measurement is less than 5 ohms.Results:
OK - The resistance measurement is less than 5 ohms. The circuit is correct. Proceed to Test Step 4.
NOT OK - The resistance is greater than 5 ohms. The circuit is not correct.