ELECTRONICS GP-MONITOR 3967452 - Caterpillar

3967452 ELECTRONICS GP-MONITOR Caterpillar parts 770G, 772G

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA3967452
396-7452
3967452

Caterpillar 3967452 ELECTRONICS GP-MONITOR

Buy ELECTRONICS GP-MONITOR 3967452 Caterpillar genuine, new aftermarket tractor parts with delivery
TRUCK,

Compatible equipment models: 3967452:

TRUCK 770G 772G Caterpillar

For full view, you need register

Information:

Stick Out (1) - Move the control lever to this position in order to move the stick outward.
Swing Right (2) - Move the control lever to this position in order to swing the upper structure to the right.
Stick In (3) - Move the control lever to this position in order to move the stick inward.
Swing Left (4) - Move the control lever to this position in order to swing the upper structure to the left.
Boom Lower (5) - Move the control lever to this position in order to lower the boom.
Tool (Raise) (6) - Move the joystick to this position in order to raise the tool.
Boom Raise (7) - Move the control lever to this position in order to raise the boom.
Tool (Lower) (8) - Move the joystick to this position in order to lower the tool.HOLD (9) - When the control lever is released from any position, the control lever will return to the HOLD position. Movement of the upper structure will stop.Two functions may be performed at the same time by moving a joystick diagonally.
Illustration 2 g01033436The pedal is located to the left of the travel pedals.
Fore Boom Extend (10) - Push down on the toe end of the pedal in order to extend the fore boom.
Fore Boom Retract (11) - Push down on the heel end of the pedal in order to retract the fore boom.
Illustration 3 g01033440
Rotate Clockwise (12) - Move the slide upward in order to rotate the work tool clockwise.
Rotate Counterclockwise (13) - Move the slide downward in order to rotate the work tool counterclockwise.
Close (14) - Move the slide upward in order to close the work tool.
Open (15) - Move the thumb slider downward in order to open the work tool.
Engine Start AEC (16) - Press the front of the switch in order to activate low engine speed. Press the switch again in order to activate high engine speed.
Hammer Enable Switch (17) - Press the front of the switch in order to enable the hammer.
Horn (18) - Push down on the switch in order to activate the horn.Note: The previous functions may be different depending on upon the configuration of the tools.