VBD1800 Lafayette 3616 Engine Caterpillar parts
G3616
Rating:
Alternative (cross code) number:
CAVBD1800
VBD-1800
VBD1800
CAVBD1800
VBD-1800
VBD1800
GAS ENGINE,
Compatible equipment models: VBD1800:
For full view, you need register
Information:
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
Certain circuits are located in the incorrect location on 479-1866 Control Harness As for certain Cat® products.Solution
Caterpillar is aware of this problem, but a permanent repair has not been defined. As an interim action, perform the following rework procedure:
Illustration 1 g06233636
View of control harness assembly
(A) "TC-C1" 70-pin connector
(1) 479-1866 Control Harness As
Locate the 70-pin connector (A) labeled "TC-C1" on 479-1866 Control Harness As (1). Remove the 70-pin connector (A) from the bulkhead.
Remove the following circuits from the following pins:
E710-BU(Blue)from pin 57
F712-GN(Green)from pin 50
F711-YL(Yellow)from pin 34
Insert the pins that were removed into the following contacts on the 70-pin connector "TC-C1".
E710-BU(Blue)into pin 58
F712-GN(Green)into pin 34
F711-YL(Yellow)into pin 50
Re-connect the 70-pin connector (A) to the bulkhead.
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.Problem
Certain circuits are located in the incorrect location on 479-1866 Control Harness As for certain Cat® products.Solution
Caterpillar is aware of this problem, but a permanent repair has not been defined. As an interim action, perform the following rework procedure:
Illustration 1 g06233636
View of control harness assembly
(A) "TC-C1" 70-pin connector
(1) 479-1866 Control Harness As
Locate the 70-pin connector (A) labeled "TC-C1" on 479-1866 Control Harness As (1). Remove the 70-pin connector (A) from the bulkhead.
Remove the following circuits from the following pins:
E710-BU(Blue)from pin 57
F712-GN(Green)from pin 50
F711-YL(Yellow)from pin 34
Insert the pins that were removed into the following contacts on the 70-pin connector "TC-C1".
E710-BU(Blue)into pin 58
F712-GN(Green)into pin 34
F711-YL(Yellow)into pin 50
Re-connect the 70-pin connector (A) to the bulkhead.