TERMINAL-RING 3727347 - Caterpillar

Removal Procedure
Start By:
Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Engines with 14 Bolt Housing Assembly
Illustration 1 g00632744
The flywheel housing has been removed for photographic purposes only.
Remove bolts (1) from housing (3).
Remove socket head bolts (2) from housing (3).
Remove the crankshaft rear seal, the gasket, and housing (3) from the dowels in the cylinder block. Engines with 10 Bolt Housing Assembly
Note: The 10 bolt housing assembly is manufactured as a one-piece assembly. The 10 bolt housing assembly is NOT adaptable to engines that have the 14 bolt housing assembly.
Illustration 2 g00830867
Remove the bolts in reverse order of the numbered sequence. Refer to Illustration 2.
Remove the one-piece housing assembly from the cylinder block.